Sun Microsystems Netra T4 AC100, Service And System Reference Manual

Page: 75 / 284

Chapter 4 Troubleshooting 4-23
6. At the
ok
prompt, type
obdiag
. Verify that the OBDiag menu is displayed
(
CODE EXAMPLE 4-10
).
dimm-fru dimm-fru dimm-fru dimm-fru dimm-fru dimm-fru i2c cpu-fru
temperature cpu-fru hardware-monitor hardware-monitor
hardware-monitor temperature fan-control fan-control motherboard-fru
ioexp ioexp ioexp fcal-backplane scc-reader lomlite2 nvram idprom
beep rtc gpio pmc parallel lombus SUNW,lomc serial lomp lomv
Memory Configuration:
Segment @ Base: 0 Size: 2048 MB ( 4-Way)
SUNW,Netra-T4
Probing /pci@8,600000 Device 4 SUNW,qlc fp disk
Probing /pci@8,600000 Device 1 Nothing there
Probing /pci@8,700000 Device 5 network usb
Probing /pci@8,700000 Device 6 scsi disk tape scsi disk tape
Probing /pci@8,700000 Device 1 Nothing there
Probing /pci@8,700000 Device 2 Nothing there
Probing /pci@8,700000 Device 3 Nothing there
Probing /pci@8,700000 Device 4 Nothing there
Sun Netra T4 (2 X UltraSPARC-III) , No Keyboard
Copyright 1998-2001 Sun Microsystems, Inc. All rights reserved.
OpenBoot 4.2, 2048 MB memory installed, Serial #16458092.
Ethernet address 8:0:20:fb:21:6c, Host ID: 80fb216c.
{0} ok
CODE EXAMPLE 4-10 obdiag
Menu
o b d i a g
1 SUNW,lomv@0,0 2 SUNW,qlc@4 3 bbc@1,0
4 ebus@5 5 flashprom@0,0 6 gpio@1,300600
7 i2c@1,2e 8 i2c@1,30 9 network@5,1
10 parallel@1,300278 11 pmc@1,300700 12 rtc@1,300070
13 scsi@6 14 scsi@6,1 15 serial@1,400000
16 usb@5,3
|Commands:test test-all except help what printenvs setenv versions exit|
CODE EXAMPLE 4-9
Typical
reset-all
Screen Output (Continued)