Sun Microsystems Netra T4 AC100, Service And System Reference Manual

Page: 46 / 284

3-2 Netra T4 AC100/DC100 Service and System Reference Manual • August 2001
SunVTS executes multiple diagnostic tests from a graphical user interface (GUI) or
TTY interface that provide test configuration and status monitoring.
The SunVTS interface can run on one system to display the SunVTS test session of
another system on the network.
SunVTS is distributed with each Solaris release. It is located on the Sun Computer
Systems Supplemental CD.
3.1.1 SunVTS Requirements
Your system must meet the following requirements to run SunVTS:
■
The SunVTS packages must be installed. The main package is
SUNWvts
. There
are additional supporting packages that differ with the revision of the Solaris
operating system that is installed. See also Section 3.1.3, “Installation” on
page 3-3 and the corresponding SunVTS documentation.
■
The system must be booted to the multiuser level (level 3).
■
To run SunVTS with a GUI (CDE or Open Look), that GUI must be installed.
Otherwise, run SunVTS with the TTY-mode interface.
3.1.2 SunVTS References
To find out more information about the using SunVTS, refer to the SunVTS
documentation for the Solaris release that you are running.
The SunVTS documents are part of the Solaris on Sun Hardware AnswerBook
TM
collection. This AnswerBook collection is pre installed on the hard disk of new
systems. It is also distributed on the Software Supplemental CD that is part of each
Solaris Media Kit release and is also accessible at
http://docs.sun.com
.
The following list describes the contents of each SunVTS document:
■
SunVTS User’s Guide describes how to install, configure, and run the SunVTS
diagnostic software.
■
SunVTS Test Reference Manual provides details about each individual SunVTS
test.
■
SunVTS Programmer’s Guide supports the development of custom tests.