Sun Microsystems Netra T4 AC100, Service And System Reference Manual

Page: 120 / 284

8-4 Netra T4 AC100/DC100 Service and System Reference Manual • August 2001
6. Using the drive handle, ease the drive from the drive bay until you feel the drive
connector disengage from the FC-AL backplane connector.
7. Holding the disk by the handle, slide the disk drive out of the bay.
Support the weight of the drive with your other hand to avoid unnecessary pressure
on the drive handle.
8. Place the disk drive on an antistatic mat.
8.1.3 Hot Swapping a Disk Drive (Installation)
1. Logically add the drive to the FC-AL bus by typing:
2. If necessary, lower the front fascia.
See Section 5.7.1, “Removing the Front Fascia” on page 5-11.
3. Align the disk drive with the slot in the drive bay.
4. Slide the disk drive into the drive bay until it makes contact with the FC-AL
backplane connector.
Do not force it home.
5. Lock the drive in the bay by pressing on the drive handle until the drive latch
closes.
This action engages the drive with the FC-AL backplane connector.
6. Refit the front fascia.
See Section 5.7.2, “Fitting the Front Fascia” on page 5-11.
7. Press <Return> to answer the last line of Step 1.
# luxadm insert_device
The list of devices which will be inserted is:
1: Device /dev/rdsk/c1t2d0s2
Please enter q to Quit or <Return> to Continue:
Stopping: /dev/rdsk/c1t1dos2....Done
Offlining: /dev/rdsk/ccc11t1dos2....Done
Hit <Return> after insertion of the device(s)