Sun Microsystems Netra T4 AC100, Service And System Reference Manual

Page: 95 / 284

Chapter 5 Before Servicing the System 5-11
5.7.1 Removing the Front Fascia
Caution –
Exercise care when opening the fascia. You must detach the plastic
locating pegs on the bottom edge of the fascia before lowering it.
1. Pull the fascia away from the top of the chassis not more than 2.5 cm (1 in.) using
the finger hold in the middle of the fascia.
2. Lift the fascia forward and off the locating pegs on the bottom edge of the fascia.
3. Swing the fascia forward and down so that it hangs on the two plastic tethers.
5.7.1.1 Detaching the Fascia Tethers
4. Squeeze together the sides of each plastic tether and pull it from the system
chassis.
5. Similarly, squeeze together the sides of the tether to detach each locating pin in
turn from the retainers on the fascia.
5.7.2 Fitting the Front Fascia
Follow Step 1 through Step 5 if you are refitting the tethers to the fascia, otherwise
start at Step 6.
1. Insert one side of the locating pin on the tether in the retainer on the fascia.
2. Squeeze the sides of the tether together to insert the other locating pin.
3. Repeat Step 1 and Step 2 for the other tether.
4. Insert the other end of one of the tethers in the corresponding slot in system
chassis.
If the tether is a tight fit, squeeze the sides of the tether together.
5. Repeat Step 4 for the other tether.