Sun Microsystems Netra 120, User Manual

Page: 92 / 200

7-2 Sun Fire V120 and Netra 120 Server User’s Guide • December 2001
7.1 Preparing to Configure the Server
To perform the initial configuration of the Sun Fire V120 or Netra 120 server, set up
a serial connection using the port labeled Serial A/LOM on the server’s back panel
(see Chapter 6). Make sure you have the server’s power cord(s) connected (see
Chapter 6).
7.1.1 Using a Terminal Server
● To access the Sun Fire V120 or Netra 120 server from a Sun workstation through a
terminal server, open a terminal session on the Sun workstation and type:
For example, for a Sun Fire V120 server connected to port 10000 on a terminal server
whose IP address is 192.20.30.10, you would type:
7.1.2 Configuring From a Terminal or Workstation
● To access the server from a dumb terminal, set up a connection between the
terminal and the server.
●
To access the server from a Sun workstation that is directly connected to the
server, set up the connections between the devices, then open a terminal session
and type:
The
tip
command above assumes that your console is using its
ttya
port. If you
later configure your console to use its
ttyb
port, you will need to type the following
to set up a
tip
session:
# telnet
IP-address-of-terminal-server port-number
# telnet 192.20.30.10 10000
# tip /dev/term/a -9600
# tip /dev/term/b -9600