Sun Microsystems Netra 120, User Manual

Page: 189 / 200

Appendix C Configuring the LOM Device Driver C-3
C.2 Configuring the LOM Device Driver
The full list of parameters you can set in this file is given in
TABLE C-1
.
TABLE C-1
LOM Configuration File Parameters
Field Format Default Effect
wdog_reset=
Boolean
0=FALSE
1=TRUE 0 Causes the LOM to reset the
server after a watchdog timeout.
Setting this to 1 is equivalent to
using the
lom -R on
command
described in Chapter 9.
wdog_alarm3=
Boolean
0=FALSE
1=TRUE 0 Turns on software alarm 3 when
the LOM watchdog times out.
serial_events=
0=OFF
1=ON
2=ON
WHEN
DRIVER
NOT
LOADED 2 Causes the LOM to report
events over the serial
connection. Setting this
parameter to 0 means that no
events will be reported over the
serial connection. Setting it to 1
means that events will be
reported over the serial
connection as well as to
syslogd
; this is equivalent to
lom -E on
. If you have
dedicated the Serial A/LOM
port to the LOM device, you
need to set this parameter to 1.
It ensures that you receive all
event reports at the terminal
you have connected to Serial
A/LOM. Finally, setting the
parameter to 2 means that
events will be reported over the
serial connection, but only
when the driver is not running
(when it is running they will be
reported to
syslogd
).
disable_wdog_on_break=
Boolean
0=FALSE
1=TRUE 1 Causes the LOM to disable its
watchdog if it detects a break
signal on the Serial A/LOM
port.