Sun Microsystems Netra 120, User Manual

Page: 182 / 200

A-4 Sun Fire V120 and Netra 120 Server User’s Guide • December 2001
A.2 Removing a SCSI Hard Disk Drive With
Solaris Running
If you are removing a Hard Disk Drive while the Operating System is still running,
you must remove the drive logically from the Operating System before removing it
physically. Follow the instructions in this section, then remove the Hard Disk Drive
physically by following the instructions in Section 4.1, “Installing and Removing
Hot-Pluggable SCSI Hard Disk Drives” on page 4-2.
We recommend you use the instructions below in conjunction with the
cfgadm(M)
man page.
1. Check that the Hard Disk Drive you want to remove is visible to the Operating
System.
To do this, type the following:
2. Next find out the correct
Ap_Id
label for the Hard Disk Drive that you want to
remove.
To do this, type the following:
# format
Searching for disks...done
AVAILABLE DISK SELECTIONS:
0. c0t0d0 <SUN36G cyl 24427 alt 2 hd 27 sec 107>
/pci@1f,0/pci@1/scsi@8/sd@0,0
1. c0t1d0 <SUN36G cyl 24427 alt 2 hd 27 sec 107>
/pci@1f,0/pci@1/scsi@8/sd@1,0
# cfgadm -al
Ap_Id
Type Receptacle Occupant Condition
c0 scsi-bus connected configured unknown
c0::dsk/c0t0d0 CD-ROM connected configured unknown
c1 scsi-bus connected configured unknown
c1::dsk/c1t0d0 disk connected configured unknown
c1::dsk/c1t1d0 disk connected configured unknown
c2 scsi-bus connected unconfigured unknown