Sun Microsystems Enterprise 250, Owner'S Manual

Page: 221 / 369

What Next
To reassemble the system, complete these tasks:
4
“How to Install the Fan Tray Assembly” on page 151
4
“How to Install the Side Access Panel” on page 62
4
“How to Install a Power Supply” on page 155
When you are ready to restart the system, be sure to run POST and OpenBoot
Diagnostic tests to verify that the system functions correctly with the new parts you
have just installed. For additional information, see Chapter 12.
How to Connect the System Cables
Before You Begin
Complete these tasks:
4
“How to Power Off the System” on page 55
4
“How to Remove the Side Access Panel” on page 60
4
“How to Avoid Electrostatic Discharge” on page 64
4
“How to Remove the Fan Tray Assembly” on page 150
What to Do
1. Identify the cable you wish to install or replace. Use the information in the
following tables and illustrations to determine where to connect each end
of the cable.
Each cable connector is keyed so that it can be connected in only one way.
2. Install the cable according to the routing and cable management instructions
provided in the table.
Note -
Part numbers listed in this section are correct as of the manual publication
date but are subject to change without notice. Consult your authorized Sun sales
representative or service provider to confirm a part number prior to ordering a
replacement part.
Removing and Installing Backplanes and Cables
187