Sun Microsystems Enterprise 250, Owner'S Manual

Page: 195 / 369

Figure 8–11
8. Grasp the corner of the LED ribbon cable, and fold the cable under itself, so
that the label at the end is facing up.
Make sure that the adhesive strip at the corner of the cable is also facing up.
9. Feed the end back into the disk bay opening and route it on top of the disk
cage toward the upper-left corner of the UltraSCSI backplane.
Arrange the middle portion of the cable so that it lies flat across the top of the
disk cage at the front of the chassis.
10. Connect the LED ribbon cable to connector J0602 on the UltraSCSI backplane.
This connector is located at the upper-left corner of the backplane (as viewed
from the front). Make sure that the label at the end of the cable faces up. Press
down the connector collar to secure the connection.
11. Secure the LED ribbon cable to the underside of the removable media shelf.
At the front-left corner of the system, the LED ribbon cable should be secured to
the underside of the removable media shelf. The corner of the cable has a strip of
double-sided adhesive tape. Peel off the paper backing from the adhesive strip,
and secure the cable to the underside of the removable media shelf.
12. Connect the keyswitch cable to connector J0601 on the UltraSCSI backplane.
Removing and Installing Miscellaneous Assemblies
161