Sun Microsystems 5500, Reference Manual

Page: 135 / 304

Chapter 8 Internal SCSI and Storage Devices 8-7
8.2.3 Enterprise 4500 Tape or CD-ROM Drive
To remove and replace an existing device, perform steps 1 through 5. To install a
tape drive for the first time, proceed to step 6.
Note – For cooling purposes, the tape drive must be installed on the side nearest the
key switch.
1. Unlock and remove the front panel bezel.
a. To unlock the bezel, press inward on the serrated edges at the lower left and
right sides.
b. Tilt the bezel up 45 degrees to remove it (
FIGURE 8-6
).
2. Loosen the bottom three captive screws that hold the media tray to the chassis tray
(
FIGURE 8-7
).
3. Insert a screwdriver in the notch (
FIGURE 8-7
) at the top center of the media tray to
pull out the tray and separate it from the rear slip connectors.
4. Remove the seven screws on top of the media tray to lift off the tray cover to
access CD-ROM and tape drives.
FIGURE 8-6
Removing the Front Panel Bezel