Sun Microsystems 5500, Reference Manual

Page: 107 / 304

Chapter 5 Disk Boards and Components 5-13
FIGURE 5-8
Disk Drive with Ejector Drive Retainer Open
3. If a new drive is to be installed, proceed to the next section.
If the drive is not to be replaced, replace the Disk board as described in Section 5.5.2
“Installing a Board”.
5.5.3.2 Installing a Disk Drive
1. Inspect the shipping container upon receipt of your drive, and look for evidence
of damage.
If the carrier’s agent is not present when the container is opened, and the contents
are damaged, keep all contents and packing materials for the agent’s inspection.
2. If there is no evidence of damage, carefully remove the drive from the shipping
container.
Save the carton and the packing material for possible later use.
3. Place the antistatic mat on a table or work surface.
4. Attach a grounding wrist strap.
Refer to the documentation that came with your ESD kit.
5. Remove the disk drive from its protective packaging.
Hold the disk drive by the edges, near the middle of the drive. Keep the drive
vertical until you lay it on the ESD mat.
6. Place it on the antistatic mat with the component side of the disk drive controller
cards facing up.
7. Unlatch and then open the ejector drive retainer for the drive being replaced or
installed (
FIGURE 5-8
).
Latch