4
5.3 Installation procedure
Please avoid deploying near any power lines, strong magnetic environment to prevent any
abnormality after installation.
Please install this product on platform with enough bearing support. Please avoid using unstable
platform, because it may cause image dithering and the monitoring results may be affected.
The product installation position should be considered in the process of rotation to make sure
that it will not disturb with surrounding objects which may cause damage on the product. To
achieve the best performance of monitoring, it is suggested that this product should be installed
at least two meters above ground, and after installation the related warning labels should also be
set up.
The installation direction should follow the arrow, which is shown at the side face of product.to
make sure the back-end PTZ control direction corresponds with PTZ rotation direction.
When connecting the bottom of the PTZ platform output cables, please in strict follow with the
procedure in the <<Product manual>> or the labels
on the cable, and also make sure to
complete the waterproof process of the contact points.
After the installation of the product, do not force to turn the PTZ platform, which may cause
damage to PTZ platform system.
5.4 Other related matters
The product contains precise optical and electronic devices, during transportation and installation;
please keep preventing stress, severe vibration and any incorrect operation methods to avoid any
damage to the product.
Don't use and operate this product beyond limit of temperature, humidity or other of power
supply specifications.
Don't wash with strong or any abrasive detergent. A dry and soft cloth is recommended to use
when cleaning up. If the dirt is not easy to remove, you can use neutral detergent and then use
the dry cloth to wipe the product gently.
Since the window glass has been processed with special protection layer, when the visible light
camera and thermal imaging window are dirty, please wipe it with special lens paper.
5.5 Warning
Installation and maintenance of the products should be conducted by professional service personnel,
and only to use parts or accessories supplied by the manufacturer.
No matter the product is at work status or not, please don't put the camera under the sun or in front
of a strong lighting object, don't direct the camera to any bright stationary object (such as the sun) to
avoid any damage to the camera sensor.
