9
3. In the
edit mode,
short press left key in order to NOT save settings and exit the edit
mode.
4. In the
edit mode
of function “Bad pixels fixing” (
please refer to Appendix, part 1,
“Introduction of configuration of thermal camera”, sub-menu “Bad pixels fixing”, the
same as below
), in this case this button will be used as a direction key;
Right-click
: there are 4 scenarios of using this key
1. When
no menu
, short press for
near-focus
;
2. In the
non-edit mode
, short press to return to the upper level from the sub-menu (If the
current is the initial menu, then it will make no action).
3. In the
edit mode
, short press left key in order to save settings and exit the edit mode.
4. In the
edit mode
of function “Bad pixels fixing”, this button will be used as a direction key;
Up-click:
there are 3 scenarios of using this key
1.
When
no menu, Short press for E-zoom plus (+)
2. In the
non-edit mode
, it will move up cursor in cycle
3.
In the edit mote, it will use to modify parameters, and to add (like + key)to increase value
;
Down-click:
there are 3 scenarios of using this key
1. When
no menu
, Short press for E-zoom minus (-);
2. In the
non-edit mode
, it will move down cursor in cycle
3. In the
edit mote
, it will use to modify parameters, and to minus (like - key) to decrease
value;
Confirm (or M) key:
1. When
no menu
, press to increase aperture ;
2. The function of it is the same as right-click;
3. In the
edit mode
of function “Bad pixels fixing”: long press it to enter into edit state, and
through the up, down, right and left operation to move the cursor to the bad pixel. Short
press the M key for the bad pixels remark operation, and another short press will undo the
operation to cancel the replacement.
Note:
When the menu item is in the edit mode, there will be a “*”symbols in front of the option. When
exited from the edit mode, the “*” will disappear. See appendix for thermal imaging specification.
