8
Hint:
Select the active devices, and at the right side of software interface you can find the tab “change
network parameters”, here you can enter the IP address, gateway, and set a new password. Click to save
the changes; you can modify the network parameters of the device.
Important
Infrared thermal camera:
Type the IP address of the network camera in the browser address
bar to log in. The default visible light PELCO-D is 9600, address code is 1.
When first time using the browser to activate camera, a prompt to install the browser actives will be
pop up. Click download to install. After install the control, please restart the browser.
In order use the operation menu, you should press 6 lens control buttons of the keyboard (the
corresponding relationship has been as shown in the figure below) in the monitoring software.
Left-click
: there are 4 scenarios of using this key:
1. When no menu, short press for
tele-focus
;
2. In the
non-edit mode
, short press to return to the upper level from the sub-menu (If the
current is the initial menu, then it will make no action)
Up-click
Left-click
Long press
M key
Down-click
Right-click
Short press M key
