PG 7
SEAT ASSEMBLY (continued)
16.
Attach the Gunrest Side Tubes next. Line up the front and rear
holes. Use one
Nylon Washer
between both joints. Use one
2 1/2”
bolt and lock nut
at each joint as shown in
figure 11
. Do not over
tighten.
17. Repeat Step 16 for the other side.
18.
Position the Right Gunrest Pivot as shown in
figure 12
. Use one
Nylon Washer
between the joint. Secure with one
1 1/2” bolt and
lock nut
. Do not over tighten.
19. Repeat Step 18 for the other side.
20.
Slide the Gunrest Bar onto both Gunrest Pivots as shown in
figure 13
. Line up the holes and use the
Wire Lock Pins
to secure.
The Gunrest Bar can be adjusted using these pins.
21.
Ensure all bolts from Pages 3 - 5 are securely fastened
but not so tight as to prevent the seat assembly from
pivoting.
GUNREST
SIDE TUBE
(PN 82072.R50)
2 1/2” BOLTS, WASHER,
LOCK NUTS
11
NYLON
WASHER
RIGHT
GUNREST
PIVOT
(PN 82072.R65-R)
NYLON
WASHER
1 1/2” BOLTS, WASHER,
LOCK NUTS
12
GUNREST BAR
(PN 82072.R60)
1/4” WIRE LOCK PINS
14
1.
Position the Leg Base Plate and the Upper Leg as shown in
figure
15
. Notice that the angled end of the Ladder Assembly faces out and
the bolt hole is on the inside.
2.
Slide the Upper Leg into the Base Plate and
use one
1 3/4” bolt
and lock nut
to secure as shown in
figure 16.
Leave this bolt hand
tight for now.
UPPER LEG with HAND HOLD
(PN 82072.310)
15
ANGLED END
FACING OUT /
BOLT HOLE TO
THE INSIDE
LEG BASE PLATE
(PN 82072.600)
1 3/4” BOLT, LOCK NUT,
HAND TIGHT
16
Hardware Needed
5/16”-18 - 1 3/4” Bolt
- 3
5/16”-18 - Lock Nut
- 3
BASE PLATE
