PG 9
5
SETUP AND USE
PLATFORM RATCHET STRAP
1.
Attach the Ratchet with Loop End to the
yoke tube
at
location
A
as shown in
figure 29
. Put the sewn loop around
the tube (
figure 30
) and then push the ratchet through the
loop (
figure 31
) to create a cinch knot as shown in
figure
32.
2.
Attach the Short Strap for the Ratchet to the opposite
yoke tubing
at location
B
shown in
figure 29
. Loop the
free end of the strap around the tube and then through the
sewn loop. Pull to create a cinch knot. This is the platform
tie down ratchet strap.
LADDER STABILIZER STRAPS (CAM BUCKLE)
1.
Attach the two Long Stabilizer Straps to the
yoke tube
at locations
A and B in figure 29.
Use the same procedure
from
Step 1
above to create a cinch knot for each strap.
These are the two main ladder stabilizer straps.
2.
Attach the Cam Buckle end of each strap
to the bottom
ladder column
between the second and third rungs as
shown in
figure 33
. Use the same procedure to create a
cinch knot.
3.
Before setup, run the Long Stabilizer Straps to the Cam
Buckles and thread them as shown in
figure 34.
Pull the
free end on both straps until they are tight.
These two straps provide support to the ladder column
while you are setting your stand up and double as Stabilizer
straps once the stand is in place.
29
A
B
30
31
32
WARNING
!
Never Wrap The Stabilization Straps Around The
Ladder Rungs! Wrap Them Only Around The Ladder
Columns! (
see figure 33
)
33
34
