Summers ULTIMATE NT, Operator'S Manual

Page: 63 / 192

SECTION 6 - OPTION NOTES AND INSTRUCTIONS
6.3
6.4. RINSE NOZZLE WITHOUT RINSE TANK
6.5. RINSE TANK OPTION W/WAND
Assembly tips for installing rinse ball on main tank without a rinse tank Summers Ultimate Sprayer.
1. Drill one 1-1/2” diameter hole in main tank directly behind the second tank hoop in the top center of the
tank. Drill another 1-1/2” diameter hole directly behind the front hoop in a unobstructed location near the
top of the tank.
2. Locate a capped off port on pressure side of plumbing and install the reducer coupling, elbow, ball valve
and hose barb. Tighten all fl ange clamps after the new plumbing components are routed to clear obstacles.
3. Install hose connecting the ball valve with rinse ball.
RINSE HEAD OPERATION
Refer to sprayer plumbing decal for valve locations
To fl ush sprayer tank
1. Rotate tank selector valve “A” to closed position.
2. If sprayer has bottom
fi ll, verify that 2” bottom fi ll to main tank is closed and open to sprayer pump.
3. Close valve “D” to agitators.
4. Start sprayer pump and open the new valve to tank rinse nozzle.
To remove rinse water from Main tank
1. Remove bottom fi ll line.
2. Open valve “A” and valve “D”.
3. Start and run pump and discharge rinse water through spray booms.
4. After agitator line has been
fl ushed the valve can be closed to allow more complete use of water in main
tank.
Assembly tips for installing rinse tank on Summers Ultimate Sprayer.
1. Drill one 1-1/2” diameter hole in main tank directly behind the second tank hoop in the top center of the
tank. Drill another 1-1/2” diameter hole directly behind the front hoop in a unobstructed location near the
top of the tank.
2. Install 2” 3-way ball valve on end of suction plumbing by mating the fl anges. The two outlet ports will go
to the rinse tank and the main sprayer tank.
3. Sight tube and bracket with optional gauge will need to be removed prior to saddle and tank installation.
Sight tube will be relocated to the front of the rinse tank saddle support.
4. Flanged 1” hose barb elbow will get installed in the pressure side of the plumbing and will allow hook
up of 1” hose that will supply a 1” three way ball valve that is to be mounted on the saddle support. This
valve will control
fl ow to the rinse nozzle or optional wash wand.