SUMMER WAVES 12.5 Si, Installation And User Manual

Page: 14 / 24

11
2. Trial
A. The user must
“
Start the water Pump before the Machine will start. The Machine
will detect the water flow and start when it is ready.
B. The user should start the pump, check for any leakage of water and then set
suitable temperature.
C. In order to protect the swimming pool heater, the machine is equipped with a
time lag starting function, when starting the machine, the blower will run 1
minutes earlier than the compressor;
D. After the swimming pool heater starts up, check for any abnormal noise from
the machine.
VIII. Precautions
1. Attention
A. Set proper temperature in order to get comfortable water temperature to avoid
overheating or overcooling;
B. Do not place items that can block air flow near inlet or outlet area, or the
efficiency of the heater will be reduced or even stop.
C. Do not put hands into outlet of the swimming pool heater, and do not remove
the screen of the fan at any time.
D. If there are abnormal conditions such as noise, smell, smoke and electrical
leakage, please switch off the machine immediately and contact the local dealer.
Don
’
t try to repair it yourself.
E. Don
’
t use or stock combustible gas or liquid such as thinners, paint and fuel to
avoid fire.
F. In order to optimize the heating you can install heat insulation on pipes between
swimming pool and the heater. During running period of the swimming pool
heater, please use a recommended cover on the swimming pool.
G.
Connecting pipes of the swimming pool and the heater should be ≤10m, or the
heating effect of the heater cannot be ensured.
H. This series of machines can achieve high efficiency with air temperature of
+15
℃
～
+25
℃
.