SummaCut cutter
User’s Manual
Contour Cutting
3-18
6.
Press
or
to change the value to ‘OPOS Barcode’.
‘OPOS Barcode’ stays on the LCD.
7.
Press
to confirm.
An asterisk will appear before ‘OPOS Barcode’, indicating it is now the selected setting.
8.
Now load as described in section 3.3.6.
The cutter will read the barcode and send this data to the computer.
The cutting software will then automatically send the correct cutting data to the cutter.
The cutter will start sensing the OPOS markers and cut out the job.
After that the OPOS sensor will search if there is a job printed after the one that is just
finished and continue to contour-cut.
This will repeated until the all contour-cut jobs on the loaded roll are cut out.
Summary of Contents for SUMMACUT
Page 1: ...User s Manual Rev 004...
