SummaCut cutter
User’s Manual
Setup
1-3
4.
Mount the horizontal panel. Make sure that the hollow side is orientated to the same
side as the long ends of the feet (this would then be the rear).
FIG 1-5
1-5
MOUNTING HORIZONTAL PANEL
5.
Turn the stand upside down and mount the 4 casters (put the nut first in the casters,
then use the 12mm wrench.
FIG
1-6
1-6
MOUNTING THE 4 CASTERS
6.
Turn the stand the right way up again and put the machine on the stand and secure
with 4 screws.
FIG 1-7
1-7
MOUNTING THE CUTTER ON THE STAND
7.
Mount the basket. Make sure the long tubes are used at the rear. Put a saddle clip to
keep tubes in their place.
FIG 1-8
1-8
INSTALLING THE BASKET
Summary of Contents for SUMMACUT
Page 1: ...User s Manual Rev 004...
