2-16
2.Basic splicing operation
｜
Optical fiber splicing
2. Basic splicing operation
If “Arc Power Too Weak”, “Arc Power Too Strong” or “Arc Center” is displayed,
prepare the fiber again and repeat the test until “Good arc state.” is displayed.
(Refer to the previous page.)
■
Arc test procedure
3: After “Arc Test Ready” appears,
tap the Set icon
or press the
Set key
. An arc test is started.
4: The melt back distance of the left and
right fibers and the arc center position
which are measured via image
processing are displayed on the monitor
screen. (The arc center position value is
displayed only if the position is shifted.)
2: Tap Arc Test icon .
1: As mentioned in the previous
pages, load a prepared fiber. (The
coating is removed and fiber is
cleaved.)
▸
P.2-14 Inserting fibers into the splicer
5: After “Good arc state.” displayed,
begin the fiber preparation
procedure to perform a splice.