Subaru CROSSTREK HYBRID 2016, Owner'S Manual

Page: 127 / 546

Keys and doors/Alarm system
will flash once and the security indicator
light will start flashing rapidly. After rapid
flashing for 30 seconds (standby time), the
indicator lights will then flash slowly (twice
approximately every 2 seconds), indicat-
ing that the system has been armed for
surveillance.
!
To arm the system using the key-
less access function
1. Close all windows and the moonroof (if
equipped)
2. Turn the push-button ignition switch to
the
“
OFF
”
position.
3. Open the doors and get out of the
vehicle.
4. Make sure that the engine hood is
locked.
5. Close all doors and the rear gate.
1) Door lock sensor
Security indicator light
6. Carry the access key and touch the
door lock sensor. All doors (and the rear
gate) will lock, an electronic chirp will
sound once, the hazard warning flashers
will flash once, and the security indicator
light will start flashing rapidly. After rapid
flashing for 30 seconds (standby time), the
security indicator light will then flash
slowly (twice approximately every 2 sec-
onds), indicating that the system has been
armed for surveillance.
If any of the doors or the rear gate is not
fully closed, an electronic chirp sounds
five times, the hazard warning flashers
flash five times to alert you that the doors
(or the rear gate) are not properly closed.
When you close the door, the system will
automatically arm and doors will automa-
tically lock.
&
Disarming the system
Perform either of the following procedures.
.
Briefly press the disarm button (for less
than 2 seconds) on the access key.
.
Carry the access key and perform
either of the following procedures.
–
Grip the front door handle.
–
Press the rear gate opener button.
The following door(s) will unlock, an
electronic chirp will sound twice and the
hazard warning flashers will flash twice.
.
Driver
’
s door: when either of the
following procedures is performed
–
Press the disarm button on the
access key briefly (for less than 2
2-24