Sturtevant Richmont 10469, Operating Manual

Page: 9 / 32

Page 7
5. The voltage selector fits in a slide in the middle of
the holder. To remove the voltage selector from the
holder, simply slide it out of the channel in which it
fits.
6. When the voltage selector has been
removed, tilt it so it is oriented as
shown in the image to right. The end
that is closest to the holder and has
the top of the letters at the top is the
voltage for which the unit was set. To
change the voltage, reverse the ori-
entation of the selector so the
required voltage will be the end that
is at the bottom of the slot when the
selector is reinserted. This change of
orientation establishes the voltage setting change when the selector is reinserted.
7. Reinsert the voltage selector in the holder with
the end marked for the required voltage entering
the slot first.
8. Reinsert holder into PEM.
9. Check the voltage selector window to insure that the correct voltage now shows through
the window. If the correct voltage is displayed, the process has been properly performed.