Sturtevant Richmont 10469, Operating Manual

Page: 14 / 32

Page 12
Subnet Mask Control Cell ID
Port Number Control Channel
Message Timeout Control Name
Resend Attempts Serial Printer
Keep Alive Timeout Bar Code Reader
Time and Date
The serial printer and bar code reader functions are optional. These devices are not supplied
when the system is purchased and must be purchased separately if desired.
Programming the TCV Batch Count
This model of the TCV is capable of performing batch
counts for batches of from 1 - 99 fasteners. The batch
count controls when the batch relay closes. Batch
count data is also available to the plant floor control
system through the Ethernet communications.
To select the batch count, press the Enter button when
the TCV BATCH COUNT window is displayed.
The the display will show the current batch count. The
Up and Down arrow buttons will increment or decre-
ment the value by one fastener each time the button is
pressed. To change the count more rapidly, the Left
and Right arrow buttons will increment or decrement
the batch count by 10 fasteners.
To exit this program item without changing the value, press the Escape button at any time dur-
ing the process. To save a changed value and make it the active value, press the Enter button
after the value has been changed.
Programming the TCV Timer Min (Minimum)
Two timers control the time limits for an acceptable
switch wrench cycle (time in the “clicked” position).
The TCV Timer Min controls the minimum time specifi-
cation limit. TCV Timer Max controls the maximum
time specification limit for an acceptable cycle.
To program the TCV Timer Min specification, press
the Enter button when the TCV Timer Min window is displayed. The Timer Min window will
open. This window will show the current minimum value of the speicifation.
To exit this program menu item at any time, press the Escape button.