Sturtevant Richmont 10469, Operating Manual

Page: 20 / 32

Page 18
Programming Unit IP Address
The TCV-Ethernet acts as a server. For a server client
(remote computer) to communicate with the unit, the
client must have the internet protocol (IP) address of
the unit.
To set the local IP address for the unit, press the Enter
button when this menu item is displayed.
The current IP address will then be displayed, with one
digit underlined. To move among the address digits,
press the Left or Right buttons. To modify the under-
lined digit, use the Up or Down buttons.
To save the address after the required digits have been changed to reflect the correct address
on the network, press the Enter button. To exit this function at any time without changing the
address, press the Escape button.
Programming Gateway Address
Gateways can act as bridges between separate net-
works. For two devices to communicate between two
separate networks the messages must pass through
each respective network’s gateway.
If the two devices that are communicating are on the
same network, the gateway will not be used and the
address will not matter.
To edit the Gateway Address, press the Enter button
when the function is displayed.
The current Gateway Address will then be displayed,
with one digit underlined. To move among the address digits, press the Left or Right buttons. To
modify the underlined digit, use the Up or Down buttons.
To save the address after the required digits have been changed to reflect the correct Gateway
Address, press the Enter button. To exit this function at any time without changing the address,
press the Escape button.
Programming the Subnet Mask
The Subnet Mask allows the system to determine which IP addresses are local and which IP
addresses are remote.