Sturtevant Richmont 10469, Operating Manual

Page: 18 / 32

Page 16
Programming the TCV Channel (RF)
The radios used by the TCV-Ethernet and FM Switch
Wrench use the Zigbee Network Protocol. This allows
the use of many TCV-Ethernet units and FM Switch
Wrenches in close proximity without having to use
separate channels. Because an occasion may arise
where the user wishes to specify a channel, this ability
is provided.
To select a specific channel, press the Enter button
when the TCV Channel item is displayed.
The display will then show the current channel. Use
the Up and Down buttons to specify the desired chan-
nel. To save and activate this setting in the unit, press
the Enter button. To leave this menu item without change, press the Escape button.
If a new channel has been selected and activated, the wrench must be reproagrammed
(learned) into the unit.
Programming - Adding a Wrench (Transmitter)
The TCV-Ethernet and FM Switch Wrench work as a
system. To work together, the wrench must have a
transceiver on it and the transceiver for that particular
wrench must be “learned” (identified and recorded) by
the unit.
It is simplest to perform this function by using the key switch on the side of the unit and the pro-
cedure described later in this manual. If the key is unavailable this function can be performed
through programming.
First, clear the memory on the wrench to be “learned”
by putting it in the “clicked” position and holding it in
that position for ten (10) seconds or until the LED on
the wrench alternates between red and green.
To have the TCV-Ethernet “learn” the new wrench or one with a new transceiver, press the
Enter button when the TCV Add Wrench item is active. The display will then offer the option of
adding the wrench to the limited set of those it recognizes or not.
Press the Enter button to add the wrench and set it as the tool to communicate with or press
the Escape button to exit this program item without changing the wrench to be worked with.