E/1203/30A/37
21.3.2 TASKS ASSIGNED TO PLANT MANAGERS
Plant managers must be informed regarding potential risks in the system and must superintend
personnel that works with electrical equipment.
Superintending tasks consist of localizing possible risk situations and investigating problems
encountered by personnel when performing maintenance.
Each defective component must be immediately repaired or replaced.
The manager must insist on application of safety measures. He must not tolerate or accept deviations
from these because this could cause harm to persons or to the machinery.
21.3.3 HIGH VOLTAGE
Contact with high voltage circuits can cause burns, shock, unconsciousness or even death for the
persons involved.
This problem can be caused by poor understanding of the dangers inherent to use of electrical
devices.
Damage to the human body, in this case, depends on the intensity of current, the duration of
current and the path the current takes as it goes through the body.
21.3.4 SAFETY STANDARDS TO COMPLY WITH WHEN THE EQUIPMENT IS
SWITCHED OFF
Interrupt the power supply to the unit before opening it.
Make sure no electricity is present in the unit's circuits.
Clean and dry the work area.
Remove dowels, rings, brackets or metal parts which can hamper the job to be done or become
potential conductors for electricity.
Ground or short-circuit the terminals of the fan capacitors in the de-energized circuit.
Remove fuses only after the circuit has been deactivated.
21.3.5 SAFETY STANDARDS TO COMPLY WITH WHEN PERFORMING MAINTENANCE
ON LIVE
The following standards must be complied with, in addition to those stated at point 2.3.4 above:
· personnel must never work alone;
· work should be done, if possible, using only one hand;
· use only authorized procedures to perform by-passes at interlocks;
· make sure assigned personnel are perfectly familiar with the machine's components and
maintenance procedures before starting to work;
· use protective gloves;
· open all contacts that bring power to the equipment before measuring resistance values;
· check that there is no high voltage in the low voltage circuits;
· do not use magnetic tools near strong magnetic fields.
Summary of Contents for CVC 07 001yy
Page 2: ...E 1203 30A 2...
