Stryker altrix, Operation Manual, Page: 27 / 66

www.stryker.com 8001-009-001 REV G 23
Operation
Connecting the reusable patient temperature output cable (Continued)
To connect the reusable patient temperature output cable:
1. Insert the reusable patient temperature output cable into the patient temperature port ( Figure 8 on page 23 ).
Figure 8: Patient temperature output port
2. Connect the other end of the reusable patient temperature output cable to the external device.
Note: When Altrix is powered, the calibration of the patient temperature output is completed.
Note: If you need to calibrate the patient temperature output cable, power cycle the product by removing the plug
from the wall.
Note: For the reusable patient temperature output cable to work properly, make sure that you insert a patient
temperature probe into port A or port B.
3. Tap Confirm.
Connecting the insulated hoses
To connect the insulated hoses:
1.
To connect, push back on the retaining collar of the port on the controller ( Figure 9 on page 23 ).
Figure 9: Pull back on the retaining collar
2. Push the hose into an upper or lower port ( Figure 10 on page 23 ) and release the collar until the retaining collar
clicks into place ( Figure 11 on page 23 ).
Note: Connect a set of ports for proper water flow.
Figure 10: Connect the hoses
Figure 11: Hoses connected