Stryker 2031, Maintenance Manual, Page: 64 / 185

page 7–11
Optional Epic+ AC Crossover Board Replacement
5. Using a T27 Torx, remove the four bolts (C) at the head end of the bed holding the control bar mounting
bracket to the head end (see Figure 2).
6. Using a #2 Phillips screwdriver, remove the three screws (D) holding the control bar cover to the head
end of the bed (see Figure 3).
FIGURE 2
C
FIGURE 3
D
D D
7. Using a T–27 Torx, remove the 2 bolts holding the AC crossover board cover to the head end frame and
remove the cover.
8. Disconnect all wires from the AC crossover board.
9. Using needle nose pliers, release the four mounting stand–offs from the board and remove the board.
10. Reverse steps 9 – 12 to install the new board.
11. Reverse steps 1 – 8 of the control bar potentiometer replacement procedure on page 7–11 to reassemble
the bed.