Struers Unitom-50, Instruction Manual

Page: 26 / 225

Unitom-50
Instruction Manual
22
The contrast settings of the display can be adjusted to suit the
individual preferences.
The language can be set to English, German, French or Japanese.
The position of the cut-off wheel and the Automatic Cutting Table
(optional) can be displayed in either mm or inches.
When set to On, Unitom-50 automatically stops cutting, when the
workpiece has been cut through.
When set to Off, Unitom-50 will only stop when it reaches the pre-
set stop position or the STOP
o
key is pressed.
After cutting or after pressing STOP
o
, the return movement of
the cut-off wheel can be set to three different functions:
Top: Unitom-50 automatically retracts the cut-off wheel to the
top position.
Start: Unitom-50 automatically retracts the cut-off wheel to the
original position of the cut-off wheel, at the time you
pressed START
s
.
Stay: The cut-off wheel stays down. Use the Stay function for
bakelite bonded diamond or CBN cut-off wheels, as
retraction might destroy the rim of the cut-off wheel.
When set to On, Unitom-50 will reduce the pre-set feed speed, if it
is too high in relation to the cutting situation.
When set to Off, Unitom-50 will maintain the pre-set feed speed
throughout the cutting process. However, this might result in the
motor stopping due to overload.
The factory setting of every single value can be restored by
pressing the function key F1 when the appropriate value is
highlighted.
Display contrast
Language
Units
Autostop
Return position
Feed reduction
F1
Default value