Struers Accutom-5, Instruction Manual

Page: 20 / 236

Accutom-5
Instruction Manual
16

Open the cover and swing the right cooling tube in the air.

Insert the stop pin in the hole of the inner flange.

Use the spanner (17 mm) to loosen the flange screw.

Remove the outer flange and the wheel.

Mount the new cut-off wheel and remount the outer flange, with
the machined face towards the inner flange.

Insert the locking pin in the hole in the inner flange.

Fasten the flange screw gently using the spanner.

Swing the right cooling tube back in its place.
Cutting
Changing the Cut-off Wheel
IMPORTANT
The tolerance between the spindle and inner flange is very small which
means that the two surfaces must be absolutely clean. Never try to squeeze
the cut-off wheel on as this may damage the spindle. If there are any small
burrs remove them with grinding paper (grit size 1200).
Socket
Spanner
Stop Pin
Cooling Tube
with Plug