Struers Accutom-5, Instruction Manual

Page: 47 / 236

Accutom-5
Instruction Manual
43
4. Trouble-Shooting
Error Messages
Display Message Explanation Action
Searching for XY-reference position The machine searches for the initial
reference positions Wait for the search process to finish
Reference pos. not found, close
cover Accutom-5 was started with the
cover open and did not search for
the reference position Close the cover, wait for the
reference search to finish and press
START

Cover open!
again
You are trying to start the cutting
process or a dressing while the cover
is open Close the cover and press START

Process stopped by open cover
again
You have opened the cover during a
cutting process or a dressing
process Close the cover and restart the
interrupted process
Process running You are trying to start two different
processes at the same time Wait for the previous process to
finish and try again
Y-stop position outside cutting range
The set stop position is outside the
maximum range in the Y-direction.
(max. 105.0 mm) Adjust Y-stop position.
Y-stop position less than Y-relative You try to start a cutting process
when the relative Y-position is larger
than or equal to the Y-stop Position the specimen holder
correctly and/or change the Y-stop
position.
Feed less than 90% of pre-set value The force has exceeded the force
limit (LOW, MEDIUM, HIGH) and the
feed speed is automatically reduced
Decrease the feed speed or increase
the force limit next time you cut the
same material
Cutting stopped, feed too low The feed speed has been reduced to
less than 10% due to the force
exceeding the force limit Decrease the feed speed, increase
the force limit or change the cut-off
wheel and re-start the cutting
process
Cutting method not selected START Select a method and press

was pressed before a
cutting method was selected
START
Dressing range exceeded

again
The parameter Y-distance is set to a
value larger than the possible
movement of the table Adjust the Y-distance and press
START

again