17
PART 1 • English
En
gl
is
h
Select DVR HDD Information from the Media+ menu and press
ok
to enter.
Press
EXIT
to leave.
7.6.4 hdd format
The HDD format menu allows you to format the connected USB device.
WARnIng!
Formatting will permanently delete ALL data stored on the connected device.
Please make a backup copy of all data you wish to keep before entering the
HDD Format menu. STRONG cannot be held responsible for loss of data
from USB devices used with this receiver.
Select HDD Format from the Media+ menu and press
ok
to enter. Use
tu
to select the partition you
wish to format (Partition 1 is set per default) and press
q
to highlight Format. Press
ok
to proceed,
select FAT or Cancel, or press
EXIT
to leave without formatting.
noTE
It is possible to use already NTFS formatted USB disks.
7.6.5 dvR Configuration
This menu allows you to make settings for Time Shift and recording.
Select DVR Configuration from the Media+ menu and press
ok
to enter.
Use
pq
to move the highlight and
tu
to change settings.
Press
EXIT
to quit.
Time Shift:
On or Off. When Time Shift is set to Off, Time Shift becomes inactive.
Time Shift to Record:
On or Off. When set to On, is Time Shift also possible during record.
Record Type:
TS or PS. When TS is selected, recordings will also include subtitles and
teletext (when available). PS makes recordings without these extras.
Record Selection
Select the partition the receiver will record on.
Standby after record:
On or Off. Select if receiver must go to standby mode after Timer record.
7.6.6 Jump
The jump interval setting allows you to define the length of the fast search interval during playback
of previously recorded events. The player will jump forward or back with the set amount of time each
time you press
6
or
5
.
Select Jump from the Media+ menu and press
ok
to enter.
Use
tu
to select the desired search interval. Possible settings are: 30 Sec, 1 Min, 5 Min, 10 Min,
30 Min.
Press
EXIT
to leave the menu.
8.0 TRoublEshooTIng
There may be various reasons for abnormal operation of the receiver. Check the receiver according to
the procedures shown below. If the receiver does not work properly after checking it, please contact
your dealer or the local Service Hotline. Do NOT try to open or disassemble the receiver. It may cause
a dangerous situation and warranty will be void.
