7
PART 1 • English
En
gl
is
h
Channel No.:
Select a channel that is known to carry a broadcast in your region. The Signal
Strength and Signal Quality bars give a visual indication of the reception.
Adjust your antenna to obtain maximum signal strength and quality.
Once all settings are made, press
ok
to start scanning.
The receiver will now search for all available channels. Once scanning is finished, the receiver
switches to viewing mode.
TIP
:
In case the Welcome “Easy install” menu does not appear after switching on
the receiver the first time, reset the receiver to factory settings by pressing the
mEnu
button and selecting Load Factory Setting in submenu Tools. (Default
PIN 0000)
5.0 QuICk guIdE To usIng YouR RECEIvER
We at STRONG understand that you can’t wait to enjoy your new high definition digital terrestrial
receiver. The following quick guide will make you familiar with the basic operation of this device. We
do, however, advice you to read the full manual to get the best performance from your receiver.
To turn your receiver ON or to Standby, use the
q
button on the remote control.
Choose the desired channel with the
pq
buttons. Alternatively, you can digit the channel number
with the
0~9
buttons on the remote control. Or press
ok
in viewing mode to display the channel list.
The volume can be adjusted with the
tu
buttons.
6.0 oPERATIon
Your new receiver is equipped with several features to make watching TV a true pleasure. This
paragraph describes these features. Please also read chapter
7.0
to get familiar with the menu of
your receiver.
6.1 Changing channels
Your new receiver is equipped with four ways to change channels.
Via direct access using the
0~9
buttons.
Via the channel list trough
ok
button.
Via the
Pg+
and
Pg-
keys.
Via the
pq
keys.
6.1.1 direct access via
0~9
buttons
To gain direct access to a certain channel, simply input its number with the
0~9
keys on the remote
control. Channel numbers can be up to four digits long. Entering a number with less than four digits
is possible. Just wait a few seconds and your receiver will switch to the selected channel or press
ok
immediately after selecting the channel number.
6.1.2 Channel list
Press
ok
in viewing mode to display the Channel List. Use
pq
in the Channel List to highlight your
channel of choice and press
ok
once to select the highlighted channel. Press
ok
again to leave the
Channel List.
