STRIDE SE-MC2U-SC, User Manual

Page: 179 / 230

Stride Industrial Ethernet Switches User Manual 2nd Ed. Rev. B
Appendix D - CLI Commands
CLI Commands:
Global Commands:
The following global commands are available anywhere in the CLI:
Command Effect
commit
10% of link capacityValues are inter-validated as needed.
If valid, values are committed. Please note that this may
take some time depending on changes.
defaults
Restore factory defaults
quit
CLI is exited. Uncomitted changes are discarded without
prompting.
reset Reset the Switch.
help Print a help message.
prompt
Enable/disable the prompt (usage: “prompt enabled” or
“prompt disabled”)
When restoring factory defaults, network settings may be maintained by adding a “savenw”
option. In other words:
defaults
restores all values, but
defaults savenw
restores all defaults except the current settings for DHCP, IP address, etc…
Access Configuration:
The following administrative access settings are settable via the CLI:
Access Configuration
Parameter Default Allowable Values
snmp
both none, snmpv2, snmpv3, both
terminal
both none, telnet, ssh, both
web
both none, http, https, both
cli
1 0, 1
uitimeout
0 0 - 999
rouser
public Any valid user name
rwuser
private Any valid user name
ropass
none A password, followed by the same password repeated
rwpass
none A password, followed by the same password repeated
adminpass
admin A password, followed by the same password repeated
fwload
serial “serial” for serial firmware loading or “network” to enable Ethernet only
D-3