Remove the Top Panel
The top panel is held in place by a total of 4 screws, 2 from the bottom left
underside of the case, and 2 on the right side of the case that are accessible
between the fins of the heat sink.
Remove all 4 screws to release the top panel then separate it from the rest
of the case. Be careful not to loose those screws, they are specific to the
top panel and must be used when completing the assembly.
Remove the Drive Tray
The drive tray is held in place by 4 screws which are all accessible from the
top as shown. Once all 4 screws are removed, lift the drive tray out of the
case.
The tray will have 2 x SSD brackets pre-fitted which can also be removed.
If you have the Optical version of the FC8, the optical drive mounting
bracket will be fitted and should also be removed from the tray.
Install the I/O Shield
Locate the I/O shield supplied with your motherboard and firmly push it in
place. Ensure that it correctly seated otherwise the motherboard will be
difficult to install and not align correctly with the stand-offs.
PCS-M3x8
PPH-M3x8
PTC-M3x5
PTC-M3x3
4
