Fit Drives to the Lower Side of the Tray
The lower side of the drive tray uses slots instead of dedicated hole positions, which allow drives to be fitted anywhere along the tray and with different
orientations. The number of drives that can be fitted will depend on the exact hardware installed in the case. A maximum of 2 x 3.5" and a minimum of 1 x 3.5"
drives can be fitted. If you don’t plan on using a 3.5" drive, up to 3 x 2.5" drives can be fitted to the bottom side of the tray, or a single 3.5" and 2.5" drive side by side.
Where you position the drives on the slots is up to you and what works best to avoid conflicts with other hardware installed.
There are 5 slots that run the length of the tray, slot #1 is shared by 3.5" and 2.5" drives, slot #4 is exclusively for 2.5" drives, and the other 3 slots are for 3.5" drives,
depending on their orientation.
To attach a drive, align the mounting holes on the underside of the drive with the appropriate 2 slots on the tray then secure it using 4 screws. Note that 3.5" and
2.5" drives use different screw threads, so please make sure to use the appropriate type for each drive.
2.5" Slot #4
Shared Slot #1
2.5" & 3.5"
3.5" Drive
3.5" Drive
2.5" Drive
3.5" Slot #5
3.5" Slot #3
3.5" Slot #2
PTC-M3x5
PTC-6#32
10
