Fit Drives to the Upper Side of the Drive Tray
With the drive brackets attached, position the drives over the appropriate holes in the drive tray and secure them in place with the correct screws. it is important
not to use the wrong screws as they could damage drive that are installed on the lower side of the tray. The 2.5" drives require 2 screws per drive and has 2 fixed
mounting locations (Optical version of FC8 can only use the rear location)
If you have the OPTICAL version of the FC8, secure the optical drive in place with the 4 screws as shown, but DO NOT fully tighten the screws. Only after you
have secured the drive tray back into the case should these screws be tightened as you will need to adjust the position of the drive to line up with the front of the
case.
Lower Side Drive (Fitted in Prior Procedure)
PTC-M3x3
Drive Tray
2.5" Drive
2.5" Drive
Optical Drive
12
