63
C L E A N I N G A N D M A I N T E N A N C E
E N
8.1.2 Regular inspections
_
Condition of the bellow
_
Condition of hoses and drain pipes
▷
Keep the door gasket and the stopping surface
on the door clean. Ensure not to damage the
sealing lips.
8.1.3
Weekly maintenance
Prior to maintenance:
Before maintaining the spindle and the C/L noz-
zles, the spindle sealing air must be activated:
▷
Briefly press service button [B].
The current tool is placed down and the spindle
returns to the service position. The spindle is
released; the motor is blocked.
▷
Open the door of the milling machine.
▷
Press service button [B] on the milling machine.
The sealing air is activated. The service button
lights up.
After the maintenance
When the maintenance is completed:
▷
Shut the door of the milling machine.
▷
Briefly press operation button [A].
The tool is picked up again. The spindle travels
back to the starting position or to the position,
where the program was interrupted.
Spindle
The provided Jäger spindle service set and a mill-
ing tool of your choice are required for mainte-
nance of the spindle.
Fig. 20 Service set for Jäger spindle
1
Collet grease
2
Collet brush
3
Felt cone
4
Ejector pin
5
Spindle wrench
In order to clean the spindle:
▷
Remove any dust from the cap, the C/L pipes
and the spindle using a dry, soft cloth. Do not
use cleaning agents!
To remove the collet:
▷
Apply the black spindle wrench [5] over the col-
let.
Fig. 21
▷
Insert a milling tool into the open collet.
NOTE:
Danger of damaging the machine!
▷
Do not use compressed air, ultrasonic or a
steam jet for the cleaning!
1
2
3
5
4
5
