Stratus V 6624, Hardware Installation Manual

Page: 19 / 78

Removing the Packing Materials
Unpacking and Positioning the Cabinet 1-7
N O T I C E
Use a pallet jack, not a forklift, to move the packaged
system. Using a forklift could damage the system. Use the
pallet jack at the front or rear of the cabinet.
3. Position the cabinet pallet so that it has the clearances shown in Figure 1-3 .
Removing the Packing Materials
W A R N I N G !
To avoid personal injury or damage to the system, two
persons are required to perform the following
procedures
.
1. Orient the system package so that the package and the ramp have, as a minimum,
the clearance shown in Figure 1-3 . Also, verify that you have enough clearance
above the system to remove the top cardboard cap.
2. With one person holding the ramp in place, use the metal shears to cut the exterior
shipping straps. To avoid injury while cutting each strap, hold the strap firmly
with one hand as you stand away from it. See Figure 1-4 .
W A R N I N G !
The shipping straps snap with considerable force when
they are cut! To avoid eye or skin injuries, use caution
when cutting the shipping straps.