©
Drechselbedarf Schulte
-
Translation of the Original Instruction Manual Version 1.0
- 37
13. Troubleshooting guide
Description of problem
Possible cause
Possible solution
Machine does not turn on
•
No power
•
Motor, switch, or cable faulty
•
Cover not properly closed
•
Spindle lock or 24-position indexing
locked
•
Main switch not switched on
•
Check mains fuse
•
Contact an electrician
•
Close the cover and secure it
•
Release the lock
•
Position main switch to I
Machine switches off
•
No mains voltage
•
Frequency converter switched off
•
Check mains fuse
•
Wait about 10 minutes, then turn it on
again
Machine vibrates
•
Work piece unbalanced
•
Work piece not clamped sturdily
•
Cutting edge of tool blunt
•
Cutting pressure too high
•
Work piece clamped off-centre
•
Speed too high
•
Pulleys are loose
•
Machine positioned on uneven floor
•
Tool rest, tailstock or headstock not
locked securely
•
Compensate for imbalance, reduce speed
•
Improve clamping length or diameter,
support tailstock end, use steady rest
•
Sharpen or replace tool
•
Reduce depth of cut or feed
•
Clamp work piece centrically
•
Reduce speed
•
Tighten pulleys
•
Compensate for unevenness with
adjustable leveller
•
Check and secure, tighten self-locking nut
on the underneath
Machine judders
•
Feed too large, work piece surface
too rough
•
Wood turning tool blunt
•
Centres not aligned
•
Wood turning tool springs
•
Reduce feed
•
Resharpen wood turning tool
•
Adjust headstock
•
Move tool rest closer to work piece
Low spindle drive power
•
Work piece too big
•
Poly-V belt loose
•
Reduce belt speed
•
Retighten belt
Summary of Contents for FU-230
Page 1: ...FU 230 WOOD TURNING LATHE...