STRATOS FU-230, Instruction Manual

Page: 15 / 46

-
Fig. 12
Fig. 10 Stand
Fig. 11 Holder for movable control unit
Danger!
•
During machine assembly, always make sure that your fingers do not get trapped in
between the parts. Risk of crushing!
•
Be aware of the weight of the individual components and handle them carefully to avoid
causing yourself any injuries.
Preparing to attach the stands to the
lathe bed.
The two stands can be used on the left
and the right.
Place them flat on the floor and attach
the feet to the threaded holes on the
bottom. Secure them with suitable hex
nuts. To ensure that the wood turning
lathe
is positioned securely and
horizontally, you can alter the level
adjusting feet nuts at any time. To level
the lathe, use a commercially available
spirit level.
The feet can be omitted if the floor is
level and even and the working height is
sufficient.
The feet are used to compensate for
unevenness and to adjust the working
height by up to 50 mm (rule of thumb for
lathe height: elbow at spindle height).
Rubber mat supplied is
included to cut under feet if
not rough concrete/ground.
©
Drechselbedarf Schulte
F
Fig. 13
M
B