Installation
Leave the appliance in the base tray packaging until
you are ready to install it. When you remove the appli-
ance from the base tray packaging, take care not to
damage it.
Whilst every care is taken to eliminate burrs and raw
edges from this product, please take care when han-
dling - we recommend the use of protective gloves dur-
ing installation.
Please note that all dimensions and sizes given are
nominal, some variation is to be expected.
If this appliance is to be installed near to a corner
where the adjacent cabinets run at right angles for-
ward of the appliance, there must be a gap of at least
90mm between the appliance and the cabinets, to pre-
vent overheating of the cabinets (FIG 3).
Important:
Do not
modify the outer panels of this appliance in
any way.
Fixing screws.
The fixing screws are in a polythene bag in the oven
pack.
Depending on the method of installation, some of the
screws may not be needed.
If you have a non standard size of cabinet which leaves
a gap above or below the appliance, you may be able to
buy a trim kit (to fill in the gap) from the supplier of
your cabinets.
27
