StorageTek 9714, Hardware Operator'S Manual

Page: 26 / 76

Controlling Software
1-6 Eighth Edition 95698
■
Controlling Software
Controlling software within the customer server requests tape read/write
operations to the drives and robotic move operations to the LSM components.
The software determines where the cartridge is located by tracking the VOLSER
and cell location during audits, then allocates which drive receives the cartridge. For
specific information, refer to your software publications.
■
LSM Operating Modes
An operating mode is the manner in which an LSM and the controlling software
(also referred to as the customer server software) interact. An LSM can operate in
either automated mode or manual mode, as described below.
Automated
Automated mode is the normal operating mode of the LSM. The controlling
software instructs the robot to move the cartridge among the storage cells, drives,
and CAP without operator intervention. The operator tasks include:
• Monitoring the LSM operator display for messages
• Entering a cartridge through the CAP
• Ejecting a cartridge through the CAP
• Replacing a cleaning cartridge
Refer to Chapter 3, “Operating the LSM,” for the procedures.
Manual
Manual mode occurs when the LSM is no longer online or loses power. The
operator tasks include:
• Opening the LSM front door
• Moving the robot
• Locating a cartridge
• Removing a cartridge from the hand
• Mounting a cartridge into a drive
• Dismounting a cartridge from a drive
• Returning the LSM to online status
Refer to Chapter 3, “Operating the LSM,” for the procedures.