95698
Eighth Edition
3-3
Powering-off the LSM
■
Powering-off the LSM
To power-off the LSM:
1. Make sure that no jobs are being run by the drives or robot.
2. Press the power switch (in the bottom of the rear cover of the LSM) to the OFF
position.
■
Operating in Automated Mode
Automated mode is the normal operating mode of the LSM. When the LSM is
online and the robot is mounting and dismounting cartridges, monitor the LSM
operator panel display messages and respond appropriately.
When an LSM is online, you might need to:
•
Enter a cartridge into the LSM through a cartridge access port (CAP)
•
Eject a cartridge from the LSM through a CAP
•
Replace the cleaning cartridge
The following pages describe how to perform these activities.
Entering the Cartridge through the CAP
If the operator panel displays “ONLINE CAP UNLK DISABLD,” the CAP is
locked by the host. Issue the command at the customer server console to allow the
CAP to be unlocked. Then perform the numbered steps below.
If the operator panel displays “ONLINE - PRESS EXE TO UNLK CAP,” go
directly to the steps below.
To access the CAP so that you can enter cartridges into it:
1. Press
EXECUTE
on the LSM operator panel.
a. The panel displays “ONLINE CAP UNLK PENDING.”
b. The CAP drawer begins to slide toward you.
c. The panel displays “ONLINE CAP UNLOCKED.”
2. Pull the drawer further toward you. Hold onto the drawer.
CAUTION:
You must enter the cartridges properly or you might damage the robot or
the drive, or cause the LSM to stop operating.
3. Referring to
, enter the cartridge so that it lies flat,
with the VOLSER showing on the left side of the cartridge as you face the
LSM and the tape leader block cutout toward the LSM.
Summary of Contents for 9714
