37
Setting Interface Options for IPS Engines
2.
(
Optional
) Click
Add
to define a different contact address for contacting this engine from
some specific Location.
3.
Click
OK
to close the Contact Addresses dialog.
4.
Click
OK
to close the IP Address Properties dialog.
You can define several IP addresses for the same physical network interface. Before you
continue, write down the networks to which each Interface ID is connected.
Setting Interface Options for IPS Engines
Interface options allow you to select which interfaces are used for which types of system
communications.
To set the Interface Options
1.
Click
Options
. The Interface Options dialog opens.
2.
Select the
Primary
Control Interface for communications with the Management Server.
2
1
1
Summary of Contents for stonegate 5.2
