STOK SGP2220, Operator'S Manual

Page: 12 / 80

12
ASSEMBLY
STEP 7: ASSEMBLING ThE fRAME TO ThE
fIREBOX
See Figure 11.
Remove the following hardware from the blister pack:
AA
- 2 Screws (M5 x 12 mm)
dd
- 2 Screws (M5 x 40 mm)
BB
- 4 Flat washers (M5)
cc
- 4 Lock washers (M5)
EE
- 2 Nuts (M5)

Position the frame over the table top and firebox as shown.
NOTE:
The right side legs (with large wheels) should be
on the same side as the firebox.

Insert the 4 frame leg sections into the tubes as shown,
aligning holes in the legs with holes in the tubes.

To attach the right side of the frame, slide a lock washer
(cc) and flat washer (BB) over each screw (AA) . Insert
the screw through the holes in the legs and tubes.

To attach the left side of the frame, insert a screw
(dd)
through the holes in the legs and tubes. Add a flat washer
(BB)
, lock washer
(cc)
, and nut
(EE)
to the end of the
screw and tighten.

Make sure all hardware is securely tightened.
flAT
wAShER
(bb)
nuT
(EE)
lock
wAShER
(cc)
hoSE
ScREw
(dd)
hook
inSERT
lEgS inTo
TubES
Fig. 11
Fig. 12
ScREw
(AA)
gAS
hoSE
hoSE
bRAckET
bolT
(jj)
AcoRn
nuT
(ff)
RighT SidE
lEfT SidE
STEP 8: SEcURING GAS hOSE
See Figure 12.
There is a hook on the underside of the storage shelf for
keeping the hose in place. The hose should be attached to
the hook before turning the grill upright.
Remove the following hardware from the blister pack:
JJ
- 1 Bolt (M4 x 20 mm)
ff
- 1 Acorn nut (M5)

Fasten gas hose into hose bracket, located under prep
table.
 Slide bolt
(JJ)
through hole in bracket and secure with
acorn nut
(ff)
.
NOTE: Should not be so tight around hose as to pinch
hose.