STOK SGP2220, Operator'S Manual

Page: 21 / 80

21
OPERATION
RESETTING ThE GAS REGULATOR SAfETy
dEVIcE
Since 1995, all regulators include a safety feature that re-
stricts gas flow in the event of a gas leak. If you turn on the
control knob before turning on the cylinder valve, you can
activate this feature. Even with all the burners turned on high,
the grill won’t get hotter than 250°F to 300°F. It will then be
necessary to reset the gas regulator safety device.
To reset:

Remove the hood and turn all control knobs on the
control panel off.

Hold regulator firmly and turn coupling nut counterclock-
wise to disconnect the regulator from the LP gas cylinder.

Wait 30 seconds the reconnect the regulator.

Open cylinder valve and follow igniting instructions.
Fig. 30
TAb
RElEASE
buTTon
inSERT
Tool
USING ThE GRILL ANd AccESSORIES
See Figure 30.
To use the insert removal tool:
NOTE:
Only use the insert removal tool on ST ō K
™
inserts.

Slide the hooks on the end of the insert tool under the
tab on the insert.
wARNING:
Only place the pizza stone in cold grill. Placing the pizza
stone in a hot grill can result in possible serious injury.

Lower the tool so that the bottom latch catches under
the insert tab.

To release: Lift the orange release button with your thumb
then remove the insert removal tool from the insert.
To use the grate to grill meat:

Turn on the grill and close the hood. Preheat the grill for
10 - 15 minutes.

Remove the hood and place the meat on clean grates
then replace the hood. Cooking time will vary depending
on personal preference.
NOTE:
When grilling fish, the meat is typically done when
it flakes easily with a fork. If any part of the meat is glossy
in appearance, it is not done.

When finished cooking, turn the control knobs and cylinder
valve off.

Clean grates and grease tray.
wARNING:
Never use an accessory if the porcelain coating is
damaged or chipped. Use with a damaged coating
could result in serious personal injury if ingested.
To use the pizza stone:

Using the insert removal tool, lift and remove the grate
insert then place the pizza stone in the hole where the
grate insert was removed.
 Turn on the grill and close the hood. It will take 15 minutes
to heat the stone to a cooking temperature.

Remove the hood and place pizza on the pizza stone.
 Cook the pizza.

When finished cooking, turn the control knobs and
cylinder valve off.
 Allow the pizza stone and grill to completely cool.

Clean grates, grease tray, and pizza stone.
NOTE:
Pizza stone should not be washed with soap.
Scrape food residue off with plastic spatula and rinse
with water.
To use the vegetable tray:

Using the insert removal tool, lift and remove one of the
grate inserts.
 Turn on the grill and close the hood. Preheat the grill for
10 - 15 minutes.

Remove the hood.
 Put prepared vegetables in the vegetable tray and, using
the insert removal tool, place in the hole where the grate
insert was removed. Stir as desired.

When finished cooking, turn the control knobs and
cylinder valve off.
 Clean grates, grease tray, grease cup, and vegetable tray.
The vegetable tray is dishwasher safe.