STOK SGP2220, Operator'S Manual

Page: 11 / 80

11
ASSEMBLY
lEfT SidE
bRAcE
ScREw
(AA)
Fig. 8
Fig. 10
STEP 4: INSTALLING LEfT SIdE BRAcE ANd
cASTERS
See Figure 8.
Remove the following hardware from the blister pack:
NN - Caster tool

Set the left side brace onto each of the leg sections,
aligning the holes on each side of the brace with holes
in leg sections.

Thread the casters into holes on the left leg assembly.

Tighten casters, as shown, with caster tool
(NN)
.

Lock caster wheels.
Fig. 9
lEfT lEg
SEcTion
flAT
wAShER
(bb)
lock
wAShER
(cc)
cASTER
pREp
TAblE
holES
fiREboX
TubE
STEP 6: ASSEMBLING ThE PREP TABLE TO
ThE fIREBOX
See Figure 10.
Remove the following hardware from the blister pack:
AA - 4 Screws (M5 x 12 mm)
BB - 4 Flat washers (M5)
cc - 4 Lock washers (M5)
 Set the firebox upside down on a flat surface.

Slide the prep table into the tubes on the sides of the
firebox.

Align the holes in the right and left side brackets with the
holes in the firebox tube.
 Slide a lock washer
(cc)
and flat washer
(BB)
over each
screw
(AA)
.

Insert screws (AA) into the holes in the firebox tubes and
tighten securely.
whEEl
coTTER
pin And wAShER
(ii)
AXlE
STEP 5: INSTALLING whEELS
See Figure 9.
Remove the following hardware from the blister pack:
II - Cotter pins and washers

Slide axle all the way through axle hole in right leg brace,
so that axle appears out of both ends.

On each side of axle, slide on a wheel, then the flat washer
and secure with cotter pin (II) , as shown.
cASTER
Tool(nn)
RighT lEg
bRAcE
bRAckETS
fiREboX
TubE