Stober EZ, Manual

Page: 434 / 460

13.4 Connection to Kollmorgen drive controllers
This chapter contains the information for connecting STOBER synchronous servo motors to drive controllers
of the above-named manufacturer which differs from connecting to STOBER drive controllers. You can find
all other information about STOBER synchronous servo motors in the respective chapter of this catalog.
STOBER has taken the following measures to minimize the effort of commissioning STOBER motors con-
nected to Kollmorgen drive controllers and avoid errors during parameterization:
• The commutation offset of the motor was set so that calibration by the customer is not necessary.
• Parameter lists are provided on request.
13.4.1 Encoders
Encoders with EnDat 2.1 interface
Encoder model Code Mea-
suring
metho
d
Recordable
revolutions Resolu-
tion Position val-
ues per revo-
lution Periods per
revolution MTTF
[years] PHF [h]
EnDat 2.1 ECI 119 C4 Induc-
tive – 19 bit 524288 Sin/cos 32 > 57 ≤ 2 × 10
-6
EnDat 2.1 EQN
1125 FMA M2 Optical 4096 13 bit 8192 Sin/cos 512 > 57 ≤ 2 × 10
-6
EnDat 2.1 EQN
1125 Q4 Optical 4096 13 bit 8192 Sin/cos 512 > 57 ≤ 2 × 10
-6
Notes
• The encoder code is a part of the type designation of the motor.
• FMA = Version with fault exclusion for mechanical coupling.
• Multiple revolutions of the motor shaft can be recorded only using multi-turn encoders.
13.4.2 Possible combinations with drive controllers
The following table shows the possible combinations of STOBER synchronous servo motors with drive con-
trollers from Kollmorgen depending on the encoder model.
Drive controller Servostar S300/S400/S600/S700
Drive controller code FE
Connection plan ID 442311
Encoder Encoder code
EnDat 2.1 ECI 119 C4 EZHD, EZM
EnDat 2.1 EQN 1125 FMA M2 EZ, EZS
EnDat 2.1 EQN 1125 Q4 EZ, EZS
Resolver R0 EZ, EZS
The encoder and drive controller codes are a part of the type designation of the motor.
13.4 Connection to Kollmorgen drive controllers 13 Connecting to drive controllers of third-party manufac-
turers
434